3D Printing Stack Exchange is a question and answer site for 3D printing enthusiasts. It only takes a minute to sign up.

Sign up to join this community
Anybody can ask a question
Anybody can answer
The best answers are voted up and rise to the top

Explore our questions

0 votes
0 answers
2 views

Different direction for two extruders

3 votes
1 answer
199 views

Adjust E-step on Ender 3

1 vote
2 answers
956 views

Jerk causing vibration and Y layer shift... Bad stepper?

0 votes
0 answers
11 views

DIY 3D printer Z-axis problems

1 vote
0 answers
10 views

Print stop/starts after 3Dtouch installation

2 votes
0 answers
14 views

Layers peeling off in resin prints

1 vote
0 answers
7 views

Which firmware version is correct for my CR-5 Pro with 4.2.2 main board?

0 votes
0 answers
11 views

Print turns into spaghetti on Ender 3 Pro

0 votes
0 answers
5 views

Can I re-flash the mainboard on my CR-5 Pro using the USB port instead of the microsd card?

2 votes
1 answer
33 views

Large infill top layer almost immediately gets ruined trying to bridge

1 vote
0 answers
14 views

Chitubox: Is it possible to place a hollow object flat on the build plate and use internal supports?

7 votes
3 answers
13k views

Simultaneous heating of extruder and bed at start of print

2 votes
1 answer
519 views

BLTouch not covering the whole bed area

1 vote
1 answer
483 views

Anycubic firmware update fail and screen blinks or update firmware never ends

Browse more Questions