3D Printing Stack Exchange is a question and answer site for 3D printing enthusiasts. It only takes a minute to sign up.

Sign up to join this community
Anybody can ask a question
Anybody can answer
The best answers are voted up and rise to the top
3D Printing

Explore our questions

Ask Question
more tags
Active Hot Week Month
0 votes
0 answers
35 views

Is the BFPTouch interchangable with the BLTouch for mriscoc firmware without custom changes to Marlin?

Bob Ortiz's user avatar
Bob Ortiz
  • 561
5 votes
3 answers
11k views

How to change E0 to E1 on Marlin 1.1?

0scar's user avatar
0scar♦
  • 34.6k
2 votes
1 answer
2k views

Marlin bed leveling compensation not working

0scar's user avatar
0scar♦
  • 34.6k
2 votes
1 answer
83 views

Why is MPC better than PID for 3D printers, and (why) is it more useful for 'high-power heaters'?

agarza's user avatar
agarza
  • 1,559
1 vote
1 answer
113 views

How to distinguish filament runout and filament jam using a microswitch-based filament sensor in Marlin?

Bob Ortiz's user avatar
Bob Ortiz
  • 561
1 vote
0 answers
9 views

Is it possible to read the state of a specific printer part from Marlin, such as the power of a stepper motor, the LCD brightness, or fan speed RPM?

Bob Ortiz's user avatar
Bob Ortiz
  • 561
0 votes
1 answer
44 views

Does Marlin input shaping compensate vibration on all X, Y and Z axes?

Bob Ortiz's user avatar
Bob Ortiz
  • 561
0 votes
0 answers
366 views

Enable pins with RAMPS and M542T stepper drivers

Greenonline's user avatar
Greenonline♦
  • 6,192
3 votes
1 answer
1k views

Using the BLTouch to assist with manual bed levelling?

Bob Ortiz's user avatar
Bob Ortiz
  • 561
0 votes
1 answer
41 views

Is there a way to send a thumbnail to the printer LCD screen when printing over USB from OctoPrint?

agarza's user avatar
agarza
  • 1,559
0 votes
0 answers
51 views

Is there a way to set the installed nozzle size (and installed filament color) in the Marlin firmware (or OctoPrint software)?

agarza's user avatar
agarza
  • 1,559
0 votes
0 answers
21 views

Do OctoPrint or Marlin support "ironing" and additional printing states?

Bob Ortiz's user avatar
Bob Ortiz
  • 561
6 votes
1 answer
7k views

What is the difference between Linear Advance and Pressure Advance?

Bob Ortiz's user avatar
Bob Ortiz
  • 561
1 vote
0 answers
35 views

Aquila X3 small firmware does not flash to board

Bob Ortiz's user avatar
Bob Ortiz
  • 561
Browse more Questions

Your privacy

By clicking “Accept all cookies”, you agree Stack Exchange can store cookies on your device and disclose information in accordance with our Cookie Policy.