2022 Developer Survey is open! Take survey.

3D Printing Stack Exchange is a question and answer site for 3D printing enthusiasts. It only takes a minute to sign up.

Sign up to join this community
Anybody can ask a question
Anybody can answer
The best answers are voted up and rise to the top

Explore our Questions

6 votes
7 answers
7k views

Why is my 3D printer over extruding when I have set the flow rate very low

2 votes
2 answers
34 views

Cura variables and initial G-code commands

1 vote
1 answer
20 views

Wall thickness and line count in Cura, are they redundant, or do they multiply?

1 vote
1 answer
611 views

Cura: How to prevent my 3D printer from auto cooling after prints

2 votes
2 answers
39 views

Where can I change the nozzle diameter in Cura? Why is mine missing?

1 vote
1 answer
120 views

TronXY X1 Configure bed offsets

2 votes
2 answers
245 views

Under-extrusion halfway into print - Dremel 3D45 -PETG

0 votes
2 answers
3k views

Z offset in Marlin is not working recently

3 votes
4 answers
217 views

What techniques are needed to minimise layer separation after filament change?

2 votes
1 answer
282 views

Which slicer (Voxelizer or Cura) for Zmorph printer?

11 votes
2 answers
4k views

Cura not allowing full print area to used

4 votes
2 answers
9k views

What's the difference between "Initial Layer Width" and "Initial Layer Flow" in Cura?

7 votes
3 answers
5k views

Tuning line width and flow compensation in Cura

1 vote
1 answer
386 views

Cleaning the nozzle every Xth layer G-code

Browse more Questions