Skip to main content
3D Printing

Return to Question

spelling and grammar errors, added degree symbols and scale references.
Source Link
fred_dot_u
fred_dot_u
  • 12k
  • 1
  • 12
  • 26

I have been trying to print an object that is 4 inches tall and about. About at three3 inches it falls off the bed. I am using tape on the heated bed and right before the print I am wiping the bed with rubbing alcohol. After the first time I tried hot glueinggluing it to the bed when it was mid way thoughthrough so that Iit wouldn't fall ofoff but that didn't work. I am printing at 185185°C and the bed is 5555°C. I am using PLA to print. Should I turn upincrease the temperatetemperature of the bed or is there another thingsomething else that is wrong?

Thank You!

I have been trying to print an object that is 4 inches tall and about at three inches it falls off the bed. I am using tape on the heated bed and right before the print I am wiping the bed with rubbing alcohol. After the first time I tried hot glueing it to the bed when it was mid way though so that I wouldn't fall of but that didn't work. I am printing at 185 and the bed is 55. I am using PLA to print. Should I turn up the temperate of the bed or is there another thing that is wrong?

Thank You!

I have been trying to print an object that is 4 inches tall. About at 3 inches it falls off the bed. I am using tape on the heated bed and right before the print I am wiping the bed with rubbing alcohol. After the first time I tried hot gluing it to the bed when it was mid way through so that it wouldn't fall off but that didn't work. I am printing at 185°C and the bed is 55°C. I am using PLA to print. Should I increase the temperature of the bed or is there something else that is wrong?

Source Link
Loanb222
Loanb222
  • 367
  • 2
  • 4
  • 8

Prints falling off the bed towards the end of the print

I have been trying to print an object that is 4 inches tall and about at three inches it falls off the bed. I am using tape on the heated bed and right before the print I am wiping the bed with rubbing alcohol. After the first time I tried hot glueing it to the bed when it was mid way though so that I wouldn't fall of but that didn't work. I am printing at 185 and the bed is 55. I am using PLA to print. Should I turn up the temperate of the bed or is there another thing that is wrong?

Thank You!