Return to Question

I configured Marlin 1.1.3 for Auto-leveling with fix mounted sensor connected to Z end-stop pin.

I Enter M111 S38 to enable LEVELING+INFO+ERROR debugging. Then I enter G28 to home all axes and then enter G29 to start auto leveling. The auto leveling starts successfully and after finishing I see the scan grid in console:

Here is a visual of the leveling grid (but upside down to make it easier to view)

Naturally I DO NOT enter G28 after the scanning. I enter G0 Z1 to down nozzle almost to table. But when I enter for example G0 X25 Y30 and look at level and then I enter G0 X150 Y150 I see the big difference between nozzle levels relatively to table. So it seems that height compensation does not work. I expect that Z axis would lift up or down depending on auto leveling results but Z motor do not work when I move X/Y.

By the way I tried 3 point autoleveling. It was pretty rough but Z axis corrected it's level when I moved axes using G0 commands. And to avoid questions "why my table is inclined so much?" I deliberately inclined the table to be sure that auto leveling works. Btw I tried different Z_PROBE_OFFSET_FROM_EXTRUDER so the current 0 setting is not actual but situation is the same with any value of this option.

So what I am doing wrong?

I configured Marlin 1.1.3 for auto-leveling with a fix mounted sensor connected to the Z end-stop pin.

I enter M111 S38 to enable LEVELING+INFO+ERROR debugging. Then I enter G28 to home all axes and then enter G29 to start auto-leveling.

The auto-leveling starts successfully and after finishing I see the scan grid in console:

Here is a visual of the leveling grid (but upside down to make it easier to view):

Naturally I DO NOT enter G28 after the scanning.

I enter G0 Z1 to down nozzle almost to table. But when I enter for example G0 X25 Y30 and look at level and then I enter G0 X150 Y150 I see the big difference between nozzle levels relatively to table. So it seems that height compensation does not work. I expect that Z axis would lift up or down depending on auto-leveling results but Z motor do not work when I move X/Y.

By the way I tried 3 point autoleveling. It was pretty rough but Z axis corrected it's level when I moved axes using G0 commands. And to avoid questions "why my table is inclined so much?" I deliberately inclined the table to be sure that auto leveling works. By the way, I tried different Z_PROBE_OFFSET_FROM_EXTRUDER so the current 0 setting is not actual but situation is the same with any value of this option.

What I am doing wrong?

I configured Marlin 1.1.3 for Autoleveling with fix mounted sensor connected to Z endstop pin.

So the autoleveling scanning seems to be successfull.

I configured Marlin 1.1.3 for Auto-leveling with fix mounted sensor connected to Z end-stop pin.

So the auto-leveling scanning seems to be successful.

Here is a visual of the leveling grid (but upside down to make it easier to view)