I have a problem with my Anet A8. It is a little strange because it does not always happen.
When I turn on my printer, it freezes on boot in the second splash screen.
If I turn off and turn on several times, the printer works OK.
The printer firmware is:
- SKYNET 3D - V2.1 - BASED ON MARLIN RC7-BUGFIX - FOR ANET 3D PRINTERS
It was modified by me but I promise that I did not touch the boot section.
Could the Anet A8 motherboard be dying ? (before this issue it worked perfectly)
- Update 1:
Update 1:
- I am changing some wires (power supply and hot bed). I think it has improved... In my opinion, I think that is better change all wires...
Update 2: Some wires were black :-( (I changed them and the printer run well)
