I am printing ABS in an enclosure and most of the prints have worked out well with minor tweaking. However, the top layer always seems to split or skip a step (not sure which).
The cube is sliced in Ultimaker Cura 4.3.0 with 0.2 mm layer height, 0.4 mm nozzle, 80 °C bed on lexan and a 235 °C hotend.
The G-code to the calibration cube/chep's calibration cube is attached:
While I'm on the subject of slicing and calibration my calibration angle is coming out as before in Simplify3D, this time the layers look great but the onion skinning within the print itself so I could actually separate the calibration angle like an onion.