0
$\begingroup$

I recently added an SKR mini e3 1.2 flashed with Marlin and a BLTouch to my Ender 3. I've run through the setup and have G29 creating the mesh before my prints correctly. If I generate a mesh like:

-1 0 1
-1 0 1 
-1 0 1

My print will result in the nozzle being too low on the left and too high on the right. Is this an issue with my Z offset or is there another variable for how the compensation is calculated.

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.