3D Printing Stack Exchange is a question and answer site for 3D printing enthusiasts. It only takes a minute to sign up.
Sign up to join this community
I have installed Cura on my RPI 4 by using the "sudo apt-get install cura" terminal command.
Whenever I try to run the application, however, I get this:
Is there something wrong with the configuration files? I have tried clicking the "Backup and reset configuration", and even deleting the configuration files folder. But it doesn't help.
The regular version of Cura has system requirements that the Raspberry Pi cannot meet, including the GPU required to run it.
However, it looks like you can try an experimental version of Cura here.
