1
$\begingroup$

My printer randomly freezes partway into the print whenever I use the combination of Marlin 2.0, TMC2208 stealthchop, a 3:1 geared extruder and an E3D 0.9° stepper in a Bowden configuration on the E axis.

Is this a reasonable combination that other people have got working or is it too high of a step count (830 steps/mm) for this particular driver? If I change one of these factors it prints normally but not when they are all used together.

Improve this question
$\endgroup$
2
  • $\begingroup$ Hi welcome to 3DPrinting.SE! Maybe you could add your controller board make and model, printer type, e.g. Delta or i3? $\endgroup$
    – 0scar ♦
    Oct 16, 2020 at 6:01
  • $\begingroup$ Cross post? $\endgroup$
    – 0scar ♦
    Oct 16, 2020 at 6:54

0

Reset to default

You must log in to answer this question.

Browse other questions tagged .