1
$\begingroup$

I have an Ender 3 Pro that I installed a BLTouch sensor on. After I auto-home, I level bed and it deploys the probe in the right spot, but doesn't go down far enough, then goes back up and stops leveling.

I am using the wiring for BLTouch for Z homing on SKR mini E3 v1.2. I am using Marlin Bugfix-2.0 with BLTouch and a few other things enabled.

$\endgroup$
0
1
$\begingroup$

I think I fixed everything. What I did is I used this guide <youtu.be/y_1Kg45APko> which was a guide by makes'n'breaks on setting the probe z-offset using pronterface and then reverted to the original firmware that was on this page<github.com/bigtreetech/BIGTREETECH-SKR-mini-E3/tree/master/…> Which was the marlin firmware for bltouch for z homing for my mainboard.

$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.