1
$\begingroup$

The extruder stepper 'E' of my Ender 5 stopped working some days ago and by looking at the motherboard I found out the inductor L3 burned.

I have a Creality V2.2 (CR-10S motherboard) and I would like to change the inductor but I can't find a single datasheet of the motherboard to help me find out the inductor value.

Does anyone know it ?

The burned inductor

$\endgroup$
5
  • $\begingroup$ Do you have experience soldering surface mount elements? A new board is relatively cheap. $\endgroup$
    – Trish
    Apr 14 '21 at 10:04
  • $\begingroup$ Perfect excuse to upgrade to a modern board. Similar boards seem to use 30 Ohm (100 MHz, SKR Mini E3) to 120 Ohm (100 MHz, Fysetc Cheetah) $\endgroup$
    – towe
    Apr 14 '21 at 11:34
  • $\begingroup$ Also the skr board (e3 mini v2) is same priceish, much better (tmc's properly connected), and dropin replacement. $\endgroup$ Apr 14 '21 at 11:35
  • $\begingroup$ (The Creality silent boards have the TMC stepper drivers connected in a legacy manner where they're just emulating old-style drivers and can't be configured via the firmware. Other boards connect them properly in UART mode.) $\endgroup$ Apr 14 '21 at 14:32
  • $\begingroup$ Well I have some SMD soldering experience and I did buy a new one but it was only to repair it to have a backup motherboard in case of a new disfunctionning $\endgroup$
    – Bud
    Apr 15 '21 at 7:40

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.