I'm new to 3D printing, I just bought an Ender 3 V2 and I am having a lot of trouble with bed adhesion. After a lot of playing around it seems that the base value for Z is changing for every print.
I have been using this Z-offset test model, dialing in my Z-offset during the print until I hit an acceptable value (eg. -0.15)
If I then print the same model again, using the value I found above, it is way off again, and I have to dial it further down to maybe -0.40 and, if I repeat again, to 80.
I have, of course, tried leveling my bed multiple times
I've just been scribbling down numbers and seeing them fail for two days now, so any help is much appreciated.