I have three stepper motors each with its own stepper driver. Two of those motors have the same lead screw, while the third has a ball screw.

I need to be able to set the E-steps for the ball screw differently than the two lead screws.

Can this even be done in Marlin 2.0?


Unfortunately, It does not appear that any firmware currently available supports this feature, however you can request the feature on the marlin GitHub repository

  • $\begingroup$ I thought as much, I am going to need to get two more lead screws. $\endgroup$
    – jardane
    Jul 10 at 23:34

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.