2
$\begingroup$

I’m using the Ender 3 with the Cura slicer and I’ve had success in doing the same print but recently the layers in the middle have smushed out and I don’t know the reason why.

I’ve tried reprinting the piece and the same problem occurs in the same area. I’ve yet to try to let the part finish because I don’t really want to waste filament so whenever I see the problem I stop the print. I tried reslicing the part but the problem still happens.

Here’s the smushed print:

Image of "smushed" printed model

And here’s what it’s supposed to look like:

Image of a properly printed model

Edit: Should also mention that I’m fairly new to 3D printing

$\endgroup$
1
$\begingroup$

It looks like a problem with the Z axis. It looks like it isn’t lifting the Z as much as it thinks it is, so each layer gets over extruded because it’s trying to pack too much plastic in a shortened height. I would try cleaning and lubricating the Z rod(s) (with grease, not oil) and run the z axis up all the way and back down a few times, and watch for skipping steps or roughness in the travel.

Look for obstructions to the little wheels on the Z gantry as they roll up the frame posts. You could undo the Z gantry from the Z threaded rod. Be sure to support it on a box or something. Then lift the axis up and down by hand and feel if it’s smooth. A lot of problems with motion on 3D printer be revealed if you can work the motion by hand.

$\endgroup$
2
  • $\begingroup$ This issue appears to be in the first layers, so maybe z is starting too low. . $\endgroup$
    – Perry Webb
    Jul 20 at 15:52
  • $\begingroup$ @Perry, in the pictures you can see it starts fine, goes maybe 5mm then overextrudes. I had the exact thing happen at a certain height, it was a fouled up bearing in the z axis, (linear rail with linear bearings on my machine) making the printer skip Z steps in the same spot. $\endgroup$ Jul 22 at 0:14

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.