ABS, or preferably ASA which is "a better ABS", is probably your main option. ASA holds up better under UV/sunlight and is easier to print (less warping). Like ABS it should be printed with ventilation, and benefits some from an enclosure but can be done without it or with a primitive one (cardboard box).
A second strong candidate would be real PET (not PETG). It's hard to find as filament nowadays, and might still not have the heat resistance you want fresh off the printer, but it can be annealed with only minor dimensional changes to drastically increase heat resistance to 100 °C or higher. Strictly speaking, you can do this with PLA too, but it's hard to get it not to deform horribly when annealing unless you use 100% infill and pack it in sand or salt or something while annealing. Note that you cannot do this with PETG; it has been specifically and intentionally modified (vs normal PET) not to be able to crystallize (anneal), and to lower the temperaturse at which it softens and melts.
Another great option would be TPU. It's not subject to a glass transition temperature above room temperature (my understanding is that technically its $T_g$ is very very cold, but that may be a misunderstanding) and does not really warp/deform permanently until you reach temperatures near what you could print it at. I've used it as a mold for melting crayons in an oven at 175 ˚F (80 ˚C) with no problem. Depending on your perspective it could be easier or harder than ABS to print. If your extruder is bad at handling flex materials you might have to go really slow, or you might have trouble with jamming on retraction, but unlike ABS it has no heat/warping issues while printing and can be done even on a cold bed, and does not particularly need ventilation (although as always, be careful if you have pet birds around).
Note that while TPU is considered a "flex" material, it can be fairly rigid at high infill with rigid infill patterns like triangles or cubic, or printed 100% solid, especially if you go with harder variants. 95A is typically the highest you see but sometimes you can find 98A.