I've recently set up my Snapmaker 2.0 A350 again after moving apartments. I started by calibrating it. There was a couple of issues I'm familiar with that I could solve but one I don't know what to do about.
The corners of my CaliCat are wavy, the best I can describe them.
I'm using Cura as my slicer and the Snapmaker's filament. I know they're not good but I got it with the printer and want to finish it on less important jobs. My thermometer for the nozzle might be wrong, I was getting "elephant's foot" and drags marks in the bottom layer until I lowered the temperature to 180 °C. If I lower it to 175-170 °C, the prints fail. The rest of the settings are on default from Generic PLA and I'm using the Snapmaker profile that Cura came with.