5
$\begingroup$

Cura is generating temperature commands in the wrong order. I need to swap lines 6 and 7 below so that both the printhead and bed can begin to heat at the same time.

Is this code generation configurable in Cura?

5 ;Generated with Cura_SteamEngine 2.5.0
6 M190 S60    ; set bed and block
7 M104 S215   ; set printhead, don't block
8 M109 S215   ; set printhead, block
$\endgroup$

1 Answer 1

5
$\begingroup$

You can do so by placing this at the top of the start code under machine settings (tested on 2.6.1).

M104 S{material_print_temperature}
M190 S{material_bed_temperature}
$\endgroup$
1
  • 1
    $\begingroup$ Tested on 2.5, works perfectly. Thanks! $\endgroup$ Jul 25, 2017 at 19:25

You must log in to answer this question.

Not the answer you're looking for? Browse other questions tagged .