My printer has an auto-leveling feature that works by touching the build plate with the tip of the nozzle.
I started using a BuildTak surface and BuildTak is damaged when you push a hot nozzle into it.
So I edited the start G-code to run the auto-leveling before heating up the hotend
But ABS doesn't stick to the build surface unless I pre-heat the hotend and wait about a minute.
So now I'm looking for a G-code command to put at the end of the start G-code that will make the printer wait a minute before printing
The sequence I'm looking for is:
- Heat up the bed
- Auto level
- Raise the hotend a little bit so it doesn't touch the build plate
- Heat up the hotend
- Wait a minute (that's the only part that is missing, everything else works)
- Start printing
Any way to insert a delay into the G-code?
I'm using Cura to slice/print, my printer is Robo3D R1+