Right now my heated bed is down and I had no time to try and fix it and I am trying to print something for a friend. I am having the PLA lift around the edges which I have NEVER experienced. The glue is not helping like it did with the heat. And I also tried rubbing alcohol on the masking tape I use, heard that helps and it was not that much better than the glue stick. What can I do to keep the plastic sticking to the bed during print.

I will note that the lift is not super bad, but I do like the littlest of lift on any print.

  • $\begingroup$ Point a hair dryer at the underside of the bed :D $\endgroup$ Sep 4 '19 at 16:36

Most of the same reccomendations that apply for adhesion to a hot bed apply for a cold one. The first ones to come to mind:

  • really dial in the nozzle height
  • make the first layer taller than the rest (e.g.: 0.2mm if the rest of your print is 0.1mm)
  • print the first layer very slowly
  • print the first layer at higher temperature
  • use a brim or a raft (on my first printer, that had no heated bed, rafts gave the least deformation)
  • turn off the part fan for the first layer
  • adapt your model to reduce twisting forces (relief cuts, print it in parts, choose orientation wisely, etc...)

If your slicer has this feature, you could also try to print with a shroud.

  • $\begingroup$ Note that modern Cura has a "brim gap" option that makes brim a lot less offensive. By leaving 0.1 mm or so between the model and the brim you make it removable without damage to the print. $\endgroup$ Jun 13 '20 at 3:07

Fresh 3M blue painter’s tape coated in a watered down solution of Elmer’s white glue works wonders - even when cold - for PLA.

The tape needs to be re-applied and coated for each print for it to really stick, but it beats every other print surface I have tested for PLA other than PEI @ 70 °C. I’m guessing it has something to do with microscopic surface fibers on the tape...

(I like to print PETG as well, and that sticks too well to PEI, so I use blue 3M tape for both.)

  • $\begingroup$ I print onto painters tape on my unheated bed... so yes, this works, but the gliue is overkill XD $\endgroup$
    – Trish
    Jun 13 '20 at 6:30
  • $\begingroup$ I often eschew the glue if I’m printing a part with low risk of warping, but if I need the overkill for a higher-risk part (e.g. long narrow structural elements) then the glue can make the difference between low-warp, and no-warp. $\endgroup$ Jun 13 '20 at 13:38

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.