In a design that I need to prototype, I have a coaxial, rotational joint between 2 cylinders connected to another coaxial rotational joint between 2 cylinders by a hinge. I have attached the individual part files as well as their assembly where you can use your mouse cursor to check how they move. Click here for the SolidWorks parts and assembly files
Could you tell me an alternative method to get this complicated joint working? I need to 3D print them. I plan to use ABS for the 3D printing.
Thanks for your patience :)
EDIT: Lubrication: I plan to use grease to lubricate the sliding surfaces.
Clearances: I printed them without clearances initially (this is my first ever 3D print and I wanted to know how accurate it would be). I then used Dremel and filing tools to file away about 0.5 mm of both the surfaces. It should have been enough for mating the parts. The gap between the edges of the outer shell while trying to close it around is 3-4 mm which doesn't suggest 3D printing inaccuracy. I suspect that the outer tube isn't circular enough in cross section. It meets the inner tube at the the two ends of the semicircle and not inside its belly (you can see it in the picture). I have already tried the obvious, which is removing material from the surfaces wherever the parts touch. The model seems to be too warped for any success. The parts were printed upwards from the bottom, so it is not the warping due to gravity.