I am trying to stop the stringing that occurs on one of my prints, I have set it so that it retracts the filament which does stop it during the extrusion of the outer wall layer, however when it comes to print the inner lines of the section it does not retract at all (the extruder gear does not move back).
I am using Cura as my slicer and I cannot find any setting that would change this. My current retraction settings are as follows:
Enable Retraction - On Retract At Layer Change - On Retraction Distance - 7 Retraction Retract Speed - 40 mm/s Retraction Prime Speed - 30 mm/s Retraction Extra Prime Amount - 1 mm3 Retract Before Outer Wall - On
I am not sure how to stop this from happening, any suggestions that you can make will be greatly appreciated.