This is the model thingiverse linky
It looks like it couldn't print the edge, but this happened many many hours after printing the brim.
This did not happen with my 1st attempt at this print. The last print lost adhesion and I had to scrap it. This time, adhesion looks good so not sure why this happened.
Printing with Monoprice Select V2 with ABS, sliced with Cura. 100C bed / 250C extruder. 15mm/s initial layer speed. 60 mm/s print speed.
Update It looks like the printer is starting to smooth it out like so. Still not sure if this will lead to an ok print or will fail because of this layer. And it seems the stringing area does not have a brim underneath it. Did Cura just not calculate the brim size correctly?
Update2 Here's a few screenshots from Cura to show that the model is lying completely flat. I let the print go on overnight and here's where I stopped it It almost seems like the print shifted completely after printing the initial layer. Have you ever seen anything like this or is there anything in my Cura model that would make it do this?