1
$\begingroup$

I installed a BLTouch on my Ender 3 following this video: https://www.youtube.com/watch?v=sUlqrSq6LeY.

What I noticed too late was that when installing the BLTouch, I swapped the brown and red wires followed by connecting it to the mainboard.

Then I realized that the printer wouldn't turn on. After reading some of the comments, I swapped back the wire and I could see the BLTouch do its self-test.

However, it seems that I need to plug into the USB before the LCD + motors can work.

So is my mainboard fried? Or how should I fix it?

$\endgroup$
0
$\begingroup$

It seems like I blew the regulator based on the comment in the Reddit post: https://www.reddit.com/r/ender3/comments/ao5m5b/ender_3_can_only_be_powered_on_by_psu_and_usb/

| improve this answer | |
$\endgroup$

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.