0
$\begingroup$

During recalibration of my printer (due to the nozzle catching on the prints), the Z-axis went down where it used to go up, damaging the heatbed steel sheet in the process. It then failed calibration. I didn't change the wiring since previous print although I re-adjusted the PINDA probe. What can I do to fix this?

$\endgroup$
5
  • $\begingroup$ can you show us a photo of the situation? I barely grasp what is the problem here from you being so terse $\endgroup$
    – Trish
    Mar 24 '19 at 20:01
  • $\begingroup$ what would you like a photo of? the extruder? $\endgroup$
    – helpme
    Mar 24 '19 at 20:12
  • 2
    $\begingroup$ From the information you gave, it could have been anything. Some other possibilities would be the probe not working at all or the wires not working. $\endgroup$
    – Trish
    Mar 24 '19 at 21:04
  • 1
    $\begingroup$ Hi, could you post your comment the issue has been resolved (the PINDA probe was too high) as an answer (maybe expanding upon it as well, if possible) and mark it as accepted. That way your question will no longer be in the unanswered list. Thanks $\endgroup$
    – Greenonline
    Mar 25 '19 at 14:03
  • 1
    $\begingroup$ Welcome to the 3D printing StackExchange site. This is a great place to bring your questions, and your knowledge that can help others. To make the site as useful as possible, there are some guidelines. You can start here to read how you can best help us to help you, and how you can help others: 3dprinting.stackexchange.com/help $\endgroup$
    – cmm
    Mar 28 '19 at 13:06
1
$\begingroup$

Answer taken from OP's comment


the issue has been resolved (the PINDA probe was too high)

$\endgroup$
1
  • 1
    $\begingroup$ @helpme - If you care to submit your own actual answer, I will delete this Wiki answer, thanks. $\endgroup$
    – Greenonline
    Apr 14 '19 at 18:35

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.