Linked Questions
25 questions linked to/from What is Thermal Runaway Protection?
-1
votes
2
answers
5k
views
New Ender 3 V2 Neo keeps losing nozzle and plate temperature in the middle of the print and must be turned off to stop the print
I purchased it new from Amazon in December. It started about one week ago and it just stops with a constant beep and does not allow me to do anything else except turn it off. Doesn't happen on all ...
3
votes
2
answers
1k
views
Anet A8 Wrong Hotend Temp
My Anet A8 reads as 120ish degrees Celsius, but it is set to 200 degrees. I don't know if it is reading the wrong temperature because it still pushes out plastic when I force it. It will climb up and ...
1
vote
1
answer
1k
views
Figure out max bed temperature
I have a Tronxy X8 (yes, I know, poor choice but I didn't know better) and after some years printing PLA, PETG and TPU, I am considering trying ABS, since I got myself a second hotend which can go up ...
3
votes
1
answer
1k
views
Creality Ender 6 Heating Failed
There is a message on my Ender 6 that is telling my that my heating failed. This happened last night in the middle of a print. I have cycled the power like the screen says but the nozzle does not heat ...
2
votes
1
answer
605
views
Random hot-end temperature spikes
I've been having issues with thermal runaways lately due to random temperature spikes on my Ender 3.
I figured it was out of calibration so I did a PID tune and still had issues. I then replaced the ...
1
vote
1
answer
722
views
FlashForge Finder turns off mid print and is unable to reset or update firmware
I am new to 3D printing and am trying to get started with a FlashForge Finder. Unfortunately, the printer keeps shutting off mid print, and I am unable to find a cause. Here's what I have tried thus ...
0
votes
0
answers
420
views
CR-10 S Pro bed heating problems
I've had my bed continually heat up and not stop. I have replaced the SSR and replaced it with an identical-looking one and also replaced it with a MOSFET.
0
votes
1
answer
161
views
Extruder increase temperature
I bought a month ago the Artillery Genius. Everything was pretty good until today, I was printing a test cube and it stopped pulling out filament, when I looked the temperature it was -15 °C, a few ...
1
vote
2
answers
70
views
Long Print with Lotmaxx SC-10
I am trying to print something that might take 15 hours. I don't want to risk my printer so if I print for 15 hours, what is the worst that can happen? So far, I haven't printed anything for more than ...
1
vote
0
answers
34
views
Ender 3 V2 hotend temperature issues [duplicate]
Recently, I started experimenting with new filaments on my Ender 3 V2. I got a spool from here.
This is PETG filament and I started dialing in the temperature to run a smooth print. I found on my V2, ...