Questions tagged [anycubic-photon]
The anycubic-photon tag has no usage guidance.
5
questions
1
vote
0
answers
14
views
How to fixcrack from a print pause?
I was printing a leather mold on my Anycubic Photon Mono 4k. I needed to pause the print to refill resin vat, and at the height of the pause I got a crack. Resin is washed, but not yet cured. So how ...
- 632
1
vote
2
answers
41
views
Equipment for starting with SLA printing
I am completely new to 3D printing and want to start with SLA printing.
I found the Anycubic Photon Mono 2 printer, but on the ordering page, there are options for "Airpure" and "Wash &...
- 123
1
vote
1
answer
117
views
What could cause delamination in the raft?
I got a brand new Anycubic Photon Mono 4k about a week ago. Printer is new, FEP is clean, it was a fresh load of Anycubic Standard+ resin.
I got a couple of good prints, including perfect Cones of ...
- 632
0
votes
1
answer
63
views
Resin printer adds a small block along the far right side
My Photon Mono 4k adds a small block along the right side and no matter what I do, it still makes it. It doesn't stop it from printing but is wasting a good bit of resin. Does anybody have an idea as ...
- 1
1
vote
1
answer
888
views
Resin forming thin layer on bottom of vat (sludgelike)
I have just bought the Anycubic Photon Mono X and I am having some trouble. I was wondering if anyone else ever had this issue.
The resin seems to be hardening on the bottom of the vat after I cleaned ...
