Questions tagged [arduino-mega-2650]

The Arduino Mega 2650 is one of the most common microprocessor boards used to control 3D printers. If you think your Arduino is part of your issue, you can use this tag.

Filter by
Sorted by
Tagged with
4
votes
4answers
11k views

How to directly send G-code to printer from a Linux terminal?

Should it be possible to directly send G-code to the printer serial connection using pipes under Linux? Example: echo M106 > /dev/ttyUSB0 My controller runs ...
6
votes
1answer
796 views

Marlin menu navigation slow while printing

My Kossel Mini printer (delta) has RAMPS1.4/Arduino Mega electronics configured to use a standard 20x4 LCD display with Marlin during printing. Often, navigating the menus during print can be ...
5
votes
2answers
870 views

Wanhao i3 PLUS restarts when connecting USB

I just received my Wanhao Duplicator i3 PLUS. Everything prints and functions fine via SD card and the display but when connecting to my Mac computer the printer seems to restart. Baud Rate: 115200 ...
4
votes
2answers
541 views

Ramps 1.4 with a power brick

I'm currently designing a RepRap 3D printer that will not have a heated bed. I have heard that it is possible to use a power brick with commercial printers lacking heatbeds. Is this possible with a ...
1
vote
2answers
198 views

Is 12V and 15A enough to make work a Ramps 1.6 Plus and two stepper motors?

I want to make an order with this configuration Arduino MEGA 2650 R3 Ramps 1.6 Plus 2 TMC2130 2 Stepper motors 17hs3401 1 Fan But I am not sure what voltage and current would be enough to make it ...