Questions tagged [bridging]
The bridging tag has no usage guidance.
4
questions
2
votes
1
answer
550
views
Bridge infill does not stick to the perimeter
I'm printing small detail on Prusa Mini with Prusament PLA @ default 215 °C.
Model was sliced with the PrusaSlicer with default 0.15 mm quality profile.
The problem is that when the printer is making ...
- 121
2
votes
1
answer
2k
views
How to setup PrusaSlicer to support long bridges
Don't support bridge is a good idea to reduce support with acceptable print quality. But in this case, if I have a very long bridge and a short bridge, how do I tell the slicer to generate support ...
- 169
1
vote
3
answers
2k
views
Optimum ratio of line width to layer thickness for overhang performance?
When I have overhangs in my model, Cura colors them red. However, I noticed if I make layer thickness thinner, the red area is reduced or disappears.
This could mean that thinner layer thickness is ...
- 211
2
votes
1
answer
365
views
Sloped bridges in Cura
I'm trying to print this model of a boat:
It has 2 keels joined by 5 bridges, but the top of each keel is curved, so while the middle part is mostly flat, the bridge on the back has a bit of a slope (...
- 123