Questions tagged [creality-cr-10]

For questions about the Creality CR-10 family of 3D printers

Filter by
Sorted by
Tagged with
3
votes
1answer
646 views

CR-10S Pro pausing and starting again

I found this question, CR-10 randomly pauses for a few seconds, that someone asked earlier. I am experiencing the exact same thing, only on a CR-10S Pro. None of the suggestions on that post helped. ...
3
votes
2answers
2k views

CR-10 randomly pauses for a few seconds

I thought I have already had and fixed every problem one could possibly have with a 3D printer. Guess I was wrong. I haven't used my Creality CR-10 for a few weeks, everything was working the last ...
6
votes
1answer
6k views

Question about retraction distance and stringing/print quality with PETG

I've tried printing the Basic Stringing Test on my CR-10S using PETG (250 °C nozzle, 80 °C bed) with different retraction distances leaving all the rest unchanged. In the image below you ...
5
votes
6answers
8k views

Creality CR-10S Pro 3D printer heated bed turns off after first few layers: normal?

When I run prints on my Creality CR-10S Pro 3D printer (using Ultimaker Cura as slicer), I set the heated bed to around 70 °C for PETG. after the first few layers, the heated bed set point ...
4
votes
2answers
4k views

What are the specifications of the dual voltage controller of the Ender 3/CR-10?

Following on from What level of voltage does the Creality Ender-3 run at? Dave's answer states that both 12 V and 24 V can be used on the controller board. It also goes on to say that the ...
4
votes
2answers
3k views

How to measure the nozzle diameter?

On a Creality CR-10 Max, there is a bag of unidentified spares, which include three unmarked nozzles. There is a needle that is exactly 0.4 mm in diameter, which needle fits exactly inside one of ...
3
votes
6answers
14k views

Clogging due to heat creep: buy new cooler or new hotend?

Sadly, I am not able to "repair" my 3D printer. Every time, I want to print something that takes a bit longer to print, the extrusion stops at some point during the print (the first few layers are ...
1
vote
1answer
194 views

Wave shift pattern on the Z axis

I have a Creality CR-10S Pro V2, I've been printing regularly for one month and then, suddenly, I started to notice waves on the Z axis. They're already noticeable with the test cube but deviation ...