Questions tagged [creality]

The tag has no usage guidance.

8 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
256 views

Difference between Creality V2.1/V2.2 boards? Where to find datasheets?

I can't find an official datasheet for either board. Does anyone know where to find this information? Something that has max voltages, pinouts, etc. Also, what's the difference between the V2.1 and ...
1
vote
0answers
14 views

Creality 1.2.3 does not recognize M140 and 104?

For some reason, the Creality Slicer 1.2.3 ignores the M140 and M104 commands completely, even if I put them at the very ...
1
vote
0answers
32 views

Creality CR 6 SE firmware

I recently bought Creality CR 6 SE, I learned there are third party firmware available, I want to know which one is best known for CR-6
1
vote
2answers
77 views

Creality 10S 3D fan speed settings and bed temperature

What fan speed should I use with PLA? Do I need to manually set the fan speed in ‘Control’? Also, on the filament cartridge Bed Temp is listed: "No heat/60-80 °C". Does this mean heating the ...
1
vote
0answers
37 views

Problem with jitters with Ender 3

Recently I realized that I have been getting jitter-like rough surfaces on round parts of my models from my Ender 3. The jitters happen on the sides of the model, so the jitters would be happening in ...
0
votes
0answers
58 views

Ender 3 V2 bed slanted

I'm at a loss I have no idea what to do, I've tried everything I can think of. I've fixed my x-axis gantry, added silicon bed mounts, used washers, straightened out my BLTouch but still this is the ...
0
votes
0answers
18 views

BLTouch goes behind print bed

I want to install Marlin 2.0 on my CR20 Pro but when I try to level the bed it goes behind the bed (in my direction on the Y axis). Here is my bed config: ...
0
votes
0answers
109 views

Not moving on X and Y axis

TL;DR I moved the printer head slightly without turning off the system and now only the Z-axis stepper motors work. I recently purchased an Ender 5 Plus. I managed to get three prints done and then ...