Questions tagged [delamination]

Questions relating to the type of print failure that causes the layers to separate from one another.

2 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
4
votes
0answers
47 views

Perimeters/shells not properly fusing - delamination

I come to you all in my time of need, as I have nowhere else to turn. I’ve been a 3D printer for about two years now. I have an Ender 5 Plus. Up to this point, all of my prints were fine straight out ...
2
votes
0answers
52 views

Walls separating only on one side of print bed

Whenever I print, the walls separate when genial pressure is applied, this only happens to one side of the print, the side that faces the rear of the printer. I'm using 5 walls, so it’s only truly ...