Questions tagged [endstop]

Switch used to let the controller know the printer has reached the end of its travel in the home direction. Also known as a limit switch.

3 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
41 views

Problem setting home and getting Ender 3 basic geometry dialed in

I have the following hardware configuration: Ender 3 Pro SKR E3 Turbo Ender Extender 400XL BLTouch BTT TFT35 E3 v3.0 (Marlin/LCD and BTT/BLTouch configured) Dual Z steppers (per Teaching Tech, ...
2
votes
0answers
332 views

Marlin endstop hit message deciphering/real position

Similar to, but different from, Marlin, end stops, and position report - possible bug? This is roughly the same question, but I'm trying to understand the endstops hit response from Marlin. I'm ...
0
votes
0answers
42 views

3D printer Endstop doesn't trigger in Pronterface when depressed

I am using Makerbot endstops connected to a RAMPS 1.4/Arduino Mega 2560 setup. I am using Marlin firmware and Pronterface. When I send the M119 command, all six (I'...