Questions tagged [extrusion]

Questions about extrusion mechanisms in varying types of 3D printers or the extrusion process.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
4
votes
0answers
104 views

Inconsistent layer stacking

I'm throwing this out that as a long shot, as I'm not sure if anyone can help me, but maybe there's someone out there who had a similar issue and might have successfully dealt with this before. I'm ...
2
votes
0answers
36 views

Bioprinter does not extrude Anet A8 Marlin

I have a modified Anet A8 that is supposed to print hydrogels (paper : Ultra-Low-Cost 3D Bioprinting, Kahl M et al. 2019). For this to work, we do not need any temperature-related settings, however, I ...
2
votes
0answers
70 views

Extruder calibrated, but prints still oversized by .1 mm or so

I've got a pretty straightforward problem. In general my printer is very accurate for the XYZ movements. What I'm running into is no matter what size my print is, the XY dimensions will be thicker by ...
1
vote
0answers
37 views

What volumetric extrusion rates can the Ender 3's stock hotend achieve?

With a fully stock Ender 3, the limiting factor is almost surely the extruder, not the hotend, so I'm asking from a standpoint of having an upgraded extruder (mine is direct drive) but stock hotend. I'...
1
vote
1answer
103 views

Bed is leveled and not warped but still uneven printing?

I have the Creality CR-10S. I replaced the glass it originally came with as it was warped and I wasn't getting any material out on 2 of the sides. I switched to a PEI sheet and got the same results ...
1
vote
0answers
45 views

Top and bottom of part not coming out smooth

I have an Ender 3 printer and can not figure out why the top and bottom layer of this print comes out the way it does every print. I have tried increasing the initial layer height to 0.3 mm and ...
1
vote
1answer
66 views

Are there FDM epoxy/resin printers?

After seeing a question about FDM printing of temperature-resistant parts, high-temperature 2-part epoxy came to mind. Are there any (experimental or production) FDM extruders for laying viscous, fast-...
1
vote
0answers
156 views

Ender 3 Pro - Randomly skip lines

I am a newbie to the 3D printing world. Every night spending hours researching and troubleshooting. Recently though I am having a weird problem for which I can not figure out a solution. While ...
1
vote
0answers
223 views

How to solve this extrusion problem?

I was using this model at 100% infill to test extrusion: The printer is an old Printrbot which I converted to Klipper, so I'm doing some tests to ensure correct parameters. ABS filament 3 mm (not 2....
0
votes
1answer
1k views

Creality CR-10 problems with extrusion while printing

I have an extrusion problem with my creality CR 10 3D printer while printing. I am using a standard 0.4 mm nozzle with a 1.75 mm diameter PLA and I use Cura as my slicer. This printer ...