Questions tagged [flsun-qq]

Questions using this tag should involve the FLSUN QQ 3D printer that is manufactured by FLSUN

Filter by
Sorted by
Tagged with
0
votes
0answers
87 views

How can I improve dimensional accuracy of a delta printer?

I have a delta printer that I am trying to fine tune. I have printed a 20mm calibration cube and I get the following measurements: X: 20.5 Y: 20.3 Z: 20.0 How can ...
0
votes
0answers
206 views

Under-extrusion near the seam

I have an FLSUN QQ-S Pro and I'm trying to print a part consisting only of thin walls with PLA. I'm using Cura 4.8.0, "FLSUS QQ-S" profile. Unfortunately, near the seam there are signs of ...
2
votes
2answers
4k views

How can I print to my FLSUN QQ over WIFI

I want to be able to control my FLSUN QQ over wifi, and don't have octoprint or a raspberry pi to run it on.
0
votes
1answer
102 views

FLSUN QQ doesn't print and stops at Z=15 mm

When I try to print something that is not the test model already on the SD, which means when I try to slice something in Cura 4 and than I start the print, the nozzle stops at Z=15 mm and only ...
7
votes
1answer
3k views

How to change the voltage on a FLSUN QQ

I just bought a FLSUN QQ and the instructions say I need to change the voltage from 220 to 110. Sadly the instructions don't say how to do that. Can anyone tell me how to do it?