Questions tagged [full-graphic-smart-controller]

For questions about the interface between the user and the firmware using a 128 x 64 LCD display and a rotary dial button.

Filter by
Sorted by
Tagged with
0
votes
1answer
28 views

Makerbase MKS Slot2 V1.0 + RepRapDiscount Full Graphics LCD + RAMPS 1.4

I want to add an external SD card adapter on my RepRapDiscount Full Graphics LCD. My 3D printer is based on (Arduino Mega + RAMPS v1.4 + RepRapDiscount Full Graphics LCD). I buy an SD Card Adapter ...
4
votes
3answers
121 views

Bigtreetech upload stalled after uncommented REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER

I recently bought a BigTreeTech SKR V1.3 and uncommented REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER and clicked the upload button but faced an error that says: <...
2
votes
1answer
201 views

How to make menus more responsive in Marlin 1.1.9

I have an AM8 with an MKS GEN 1.4 board with a Bowden extruder at the moment. What I would like to do is to make my menus a bit more responsive, similar to what the guy at Lokster Space has done with ...
3
votes
1answer
31 views

Printer LCD controller required when using a Raspberry Pi + LCD?

When using a Raspberry Pi and an LCD to run the printer, can the LCD controller that comes on the printer be removed or does it need to be used also?
3
votes
0answers
121 views

How to add a patch to “Marlin_main.cpp”?

According to this question, MKS 12864OLED Display setup, I need to add a patch to "Marlin_main.cpp" but this a large file with 14789 lines of code! I don't know ...
4
votes
1answer
566 views

Connecting OLED 128x64 LCD; dogm_lcd_implementation.h is missing for patching

I'm trying to install a MKS 12864 0.96 OLED for my DIY 3D printer (see this other question). It's not listed in Marlin's LCD section of configuration.h and ...
4
votes
1answer
873 views

MKS 12864OLED Display setup

I've bought MKS 12864OLED and connected to my DIY 3d printer with Mega/RAMPS combination. In Marlin's configuration.h file there are these lines to uncomment: ...
4
votes
1answer
281 views

LCD full graphic smart controller, no character display and screen blinking

After uncommenting the REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER, the display is blinking and no characters are shown on the screen, I have already switched the ...
4
votes
1answer
2k views

How to test Arduino Mega, RAMPS 1.4 and Full Graphic Smart Controller LCD?

Unfortunately, my extruder 8825 driver ended up fried. I guess this might have damaged the Arduino Mega and RAMPS Board. I tested the Arduino Mega and I'm pretty sure that it is fried too, so I ...