Questions tagged [glass-bed]
Use this tag for questions related to glass slates used as build plate platform.
5
questions
10
votes
4
answers
4k
views
Expansion in bottom skin after first layer
I'm having an issue where prints with narrow tolerance come out fused. This makes it pretty much impossible to print anything with narrow parts. It seems to be mostly (maybe only) an issue in the ...
8
votes
1
answer
1k
views
Removeable Glass Bed vs. Removeable Springsteel Beds
Removeable beds are starting to get more common in low-price consumer-grade printers. There are pretty much 3 types:
Unheated beds
Heated beds from steel held by magnets or clips
Heated glass beds ...
7
votes
3
answers
17k
views
Will a glass bed warp as it is heated?
I purchased a glass bed to use with my still-in-transit Ender 3. Since the bed came in before the printer, I pulled it out and used a flat edge ruler to see how flat the glass surface is.
It appears ...
3
votes
2
answers
6k
views
What can cause Z height loss in the first few layers?
All my prints come out about 1 mm too short in the Z dimension. So for example a 20 mm cube comes out 19 mm high. A 10 mm cube comes out 9 mm high. The X and Y dimensions are fine. There's a little ...
2
votes
1
answer
243
views
Adhesion problem when printing calibration test
Here is my first attempt at printing a "Bed Leveling Calibration test".
It obviously didn't come out as I would have hoped, but what can you say just looking at this picture?
Is it possible to tell ...