Questions tagged [gridfinity]
Gridfinity is a standard racking/storage solution standard designed by Zack Freedman of Voidstar Labs.
2 questions
2
votes
2
answers
1k
views
Saggy vase walls. What are the tricks to successful vase mode printing?
I've tried printing in vase mode (or "spiralise outer contour" in Cura) and while the floor looks fine, the vertical sides look "saggy"
I'm using a 0.4 mm nozzle, with eSUN PLA+ at ...
- 1,114
0
votes
2
answers
257
views
What's causing this lack of layer adhesion after a crash?
I recently had a print failure/crash, where the print stuck to the nozzle and forced molten filament back into the print head, fans, and heater block.
I changed the nozzle for a new 0.4mm same as ...
- 1,114