Questions tagged [infill]

Questions about the internal structure of a 3D printed part.

Filter by
Sorted by
Tagged with
18
votes
4answers
27k views

Different infill in the same part

I´ve have read an article to change different pattern depending on amount of layers, but my question is if is possible to have different infill in the same part? For example: Base: has the infill of ...
6
votes
2answers
3k views

Infill is rough - how to enhance?

My i3 MK3 is printing very well for solid parts of an object, but it messes up with infill. As you can see in the image, the infill is broken into pieces and bends to that the surface becomes rough ...
3
votes
2answers
790 views

Using multiple infill types within one model [duplicate]

When modelling for 3D printing, can I distinguish somehow the type of infill in various areas of the model? Say there may be some areas in the model where I want 100% infill (maximum strength) but ...
29
votes
4answers
29k views

What are the advantages of gyroid infill?

I've seen a few print time-lapse videos lately which use gyroid infill: wavy lines, which deform across layers so that the waves end up alternating between the two axes. Other than making the time-...
4
votes
2answers
406 views

What is this weird support line doing in this print?

I am a newbie to 3D printing and ran into a weird infill line on my second 3D printing object on a new Qidi X-Pro machine (which works great). I've included a screenshot of the infill line, which is ...
10
votes
2answers
5k views

slic3r: Can I vary the infill percentage for different heights of my model?

How can I vary the infill percentage for different layer heights of my model? Context: The bottom part of my model needs about 20% infill. The geometry of the top part of the model (mostly cones of ...
8
votes
1answer
287 views

Unidentified problem in printing

I have printed the XY resonance, Z resonance, bridging performance and the negative space tolerance test, from Makezine (can be found here), and I have encountered the following errors in the prints. ...
4
votes
1answer
472 views

Infill failure at the far corner of two different prints

I am a complete newbie at 3D printing (although learning fast). I switched from the default Qidi slicer to the Cura slicer on a Qidi X-Pro machine (which is wonderful). Using: plate 50 °C, 0.4 mm ...