Questions tagged [makerbot-replicator2]

Questions using this tag should involve the Replicator V2 3D printer that is manufactured by Makerbot Industries

Filter by
Sorted by
Tagged with
2 votes
1 answer

Problems with noise, heat bed temperature and no X / Y endstop sensor on Makerbot Replicator 2X

I bought a used Makerbot Replicator 2X, and I have some problems printing with it. The first problem I run into is the first layer adhesion to the print bed, it seems like the temperature of the bed ...
Carl-Gustav's user avatar
4 votes
1 answer

Makerbot Replicator 2X - restarts after heating

Really need some help. Let me run you through as much as possible. I have a Replicator 2x. I've owned this for around 2 weeks now (used). after some teething issues I've been printing really well all ...
Luke's user avatar
  • 41
1 vote
0 answers

Makerbot Replicator 2 LCD screen not turning on

I recently got a MakerBot Replicator 2 from somebody. When I got it, it was not in a working state. The problem is that the LCD screen does not turn on. When turning the printer on, the 5 V and ...
Rosalie W's user avatar
  • 453
3 votes
3 answers

Replicator 2x getting too hot with silent stepper drivers

I equipped my Makerbot Replicator 2x with silent stepper drivers TMC2100. According to the product page I reduced Vref from 127 (factory default) to 25 in the printer settings as well as in my start G-...
user406482's user avatar
4 votes
1 answer

Would appreciate advice on unclogging hot end [Makerbot Replicator v2]

My Makerbot Replicactor V2 constantly jams. Usually when I go to use it after it's been off for a few hours the filament has jammed and I have to take off the front fan to remove the filament. Today, ...
daviegravee's user avatar