Questions tagged [mightyboard]
Questions about the 3D printer controller board, the MightyBoard
5
questions
0
votes
1
answer
43
views
Anycubic Chiron no display no USB - Motherboard issue?
I have an Anycubic Chiron with a Trigorilla controller board with a chip labeled "ATmega2560 16U TW 355e3f 1833amw" - However I could not find a link to the board, and there is no more info ...
4
votes
3
answers
1k
views
Can't control printer via USB
I've recently purchased a Makerbot Replicator Dual clone made by CTC. I'm in the process of upgrading/adding a few parts to it, but noticed that I can't control or print via USB.
The machine prints ...
- 143
6
votes
2
answers
277
views
Power Supply Safety
I just recently purchased a new MightyBoard (Rev G) for my Replicator that requires a new power supply.
The power supply for the Rev E was a 24 V/9.2 A which was necessary for the dual ...
- 6,284
2
votes
1
answer
927
views
What is the MightyBoard 1280 IO used for?
While I've worked on fixing my voltage regulator on my MightyBoard, I've noticed an extra set of pins available labeled Atmega 1280 IO. I've tried finding documentation on what these pin can be used ...
- 6,284
9
votes
1
answer
624
views
MakerBot Replicator 1 Voltage Regulator Fix
My Replicator (you know, the one made of balsa wood) has blown a voltage regulator on its MightyBoard for the second time. The first time, MakerBot graciously replaced it. However, they replaced with ...
- 6,284