We changed our privacy policy. Read more.

Questions tagged [mks]

The tag has no usage guidance.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
152 views

Retraction fine but recovery occasionally just doesn't happen

I'm having issues with retraction. My printer prints very well normally, but has an intermittent problem with retraction: the retraction itself always happens, but sometimes the subsequent recovery ...
1
vote
0answers
33 views

How to enable Z-offset on MKS TFT28 V4.0

I am trying to enable Z-offset on MKS MKS TFT28 V4.0 touch screen but I couldn't for some reason. This is the code that I have uploaded to the Screen firmware in which you can see that I have enabled ...
1
vote
0answers
33 views

MKS / Bigtree Closed Loop stepper the same?

Is the MKS and BigTree closed loop stepper the same? I see more responses to BigTree question. I read BigTree was plug and play and seems to be getting good support from them. I'm using the MKS ...
1
vote
1answer
83 views

Mixing (closed loop) stepper drivers on MKS main board

Can I mix BIGTREETECH S42B closed loop stepper drivers on the MKS Gen L controller board with other drivers? Are the pins in the same position? Would mixing work?
1
vote
0answers
243 views

Anycubic Kossel Delta switch from Trigorilla to MKS Gen L 1.0

I have an Anycubic Kossel Delta 3D Printer. The original Trigorilla motherboard died and I decided to buy one but I only found a Makerboard MKS Gen L 1.0 which is said to be compatible with Trigorilla....
0
votes
0answers
18 views

USB chip blown in MKS Gen L - serial communication

I have blown the USB chip on my MKS Gen L when I was trying to internally hook up the USB data lines from a Raspberry Pi to the Gen L. I found another way to serially communicate with the MKS Gen L to ...
0
votes
1answer
221 views

Error "TMC2208 or TMC2209 on Z2 requires Z2_HARDWARE_SERIAL or Z2_SERIAL_(RX|TX)_PIN

I am getting this error when I try to enable the Z2 driver for MKS Gen L V2.1 Could anyone help? Error "TMC2208 or TMC2209 on Z2 requires Z2_HARDWARE_SERIAL or Z2_SERIAL_(RX|TX)_PIN.
0
votes
0answers
48 views

How to install TMC2209 on MKS GEN L V2.1

how do I install TMC 2209 drivers into MKS GEN L V2.1 board. I do not need the home sensorless I just want to keep my dual z-axis motors cool and in sync. Thanks.
0
votes
0answers
28 views

Damaged MKS Gen_L V1.0

My MKS Gen_L V1.0 is obviously damaged. Nothing is fried on The board. I didn't see the magic smoke coming out of it. It works but I can't flash the board anymore because I get the "avrdude ...
0
votes
0answers
60 views

How to replace Trigorilla mainboard with MKS Gen L 1.0

I have the following printer: Anycubic Kossel. This has Trigorilla mainboard. My mainboard is dead and it's very expensive or almost impossible to replace it with another Trigorilla mainboard. There ...