Questions tagged [p3steel]
For questions specifically about P3Steel printers (Versions 1, 2.0, 2.01, 2.5 and 4.0 and any further versions and/or derivations using steel as a base material for the frame). This tag is not to be used for general questions about the Prusa i3 or Prusa i3 derivatives. These printers have their own tag.
4
questions
9
votes
2answers
1k views
Z axis top brackets, of P3Steel, differ between v1.x/2.x and v4
I have been studying the differences between version 2.x and version 4 of the P3Steel frames - in particular the AC08 bracket at the top of the frame which secures the top of the smooth bars and ...
8
votes
1answer
1k views
Skipping Y-steps, only when using Ultimaker Cura
In order to find out why my printer sometimes skips Y-steps (always in the same direction) only in Ultimaker Cura, I am digging into the G-code to understand the problem better. However, thousands of ...
1
vote
3answers
572 views
Is the 8mm x 20mm bearing axle for the X-axis idler (of a P3Steel) a custom part?
Here is the X-axis of the P3Steel:
The X-axis idler end of a P3Steel printer, employs an 8 mm diameter rod for the axle on which a 608zz bearing is mounted for the GT2 belt. This 8 mm rod is ...
1
vote
1answer
747 views
Orientation of long thin rod on P3Steel v4
I have a derivative of the P3Steel v4, which is not the Irobri design but another version (I'm not entirely sure which), from Poland: Frame Prusa I3 P3Steel v4.0 +RODS.
I have assembled the frame, ...