Questions tagged [print-axis-offset]

The tag has no usage guidance.

7 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
82 views

Should center point of G29 matrix always be zero?

Questions: Should repeated applications of G29 (auto-level) result in the same matrix as long as nothing is loose or has otherwise mechanically changed? Should ...
1
vote
0answers
19 views

How to enable Z-offset on MKS TFT28 V4.0

I am trying to enable Z-offset on MKS MKS TFT28 V4.0 touch screen but I couldn't for some reason. This is the code that I have uploaded to the Screen firmware in which you can see that I have enabled ...
0
votes
1answer
39 views

Ender 3 - X Axis Cannot Reach True Home

After a year of printing smaller models, I finally went to print something that would take up most of the build plate from left to right and realized that my nozzle cannot reach "true" X ...
0
votes
0answers
43 views

Help coding the MIN_POS and x/y probe offsets

I've read a lot of posts in regard to these subjects but I think that the advice is just so saturated it's hard to know what to follow. I've had trouble with my bed min pos and x/y probe offsets ever ...
0
votes
0answers
713 views

Ender 3 Pro: How to solve the issue with different Z-offsets?

I have an Ender 3 Pro with BLTouch (original) and did at least a dozen of test prints to adjust everything (steps/mm, ...). I did everything at the target temp of PLA. But I've still got the problem ...
0
votes
1answer
71 views

Z-offset issues with Slic3r and Da Vinci Nano

I was attempting to use Slic3r 1.3.0 to print to my Da Vinci Nano, using MiniMover (a replacement for xyzprint) to load the G-code. The print seemed to be a couple of millimeters off of the bed, but ...
0
votes
0answers
110 views

Z level babystepping works inconsistently after BLTouch was installed

After I installed the BLTouch sensor, the manual adjustment of the Z offset is unreliable. I found that for it to work, the software endstops must be disabled. If they are enabled, the nozzle won't ...