Questions tagged [print-failure]

Similar to the print-quality tag, but for problems where the print fails completely rather than just producing a poor result. Please include photos and describe what steps you have taken to isolate the problem (for example, what still works OK)

Filter by
Sorted by
Tagged with
2
votes
4answers
272 views

What causes this “stringing” and can my print recover from this?

Here's what it looks like This is the model thingiverse linky It looks like it couldn't print the edge, but this happened many many hours after printing the brim. This did not happen with my 1st ...
2
votes
1answer
236 views

Print layer shifting on Alunar M508 Prusa i3 clone

[Edit: My specific question is firmware error or standard layer shifting. using 2 different versions of Cura were getting quite different results from the same stl file.] Per the image below with ...
1
vote
2answers
207 views

Why did my print fall off its raft?

I just set up a refurbished MP Select Mini V2 and tried to print the test file included by the manufacturer, cat.gcode, from the included SD card. I printed in PLA (...