Questions tagged [print-failure]

Similar to the print-quality tag, but for problems where the print fails completely rather than just producing a poor result. Please include photos and describe what steps you have taken to isolate the problem (for example, what still works OK)

4 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
0answers
147 views

Ender 3 failing on brim for wide curves

When trying to print wide curves (~4inch radius), later layers of the brim seem to print too close (or over extrude, or otherwise collide) with previous layers, causing the previous layers to detach ...
1
vote
2answers
174 views

FlashForge Finder turns off mid print and is unable to reset or update firmware

I am new to 3D printing and am trying to get started with a FlashForge Finder. Unfortunately, the printer keeps shutting off mid print, and I am unable to find a cause. Here's what I have tried thus ...
0
votes
0answers
249 views

Under extrusion on one side, but only while printing support material

Trying to print a bracket for pliers, however the support material on the left side always fails by under extruding. The model is left-right symetrical, so the support is the same for both sides. ...
0
votes
0answers
45 views

Prusa i3 MK3S supports fail to print on bed

My printer currently has issues printing supports of multiple objects. The support gets smushed around the printbed after a while. I’ve attached a picture of the failed support. I’ve tried lowering ...