Last call to make your voice heard! Our 2022 Developer Survey closes in less than a week. Take survey.

Questions tagged [ramps-1.6]

For questions specifically related to the RAMPS 1.6 controller board - The RepRap Arduino Mega Pololu Shield, or RAMPS for short, is an expansion shield for the Arduino Mega designed to fit the entire electronics for a RepRap 3D printer in a small, low cost package.

Filter by
Sorted by
Tagged with
1 vote
1 answer
3k views

I can set the voltage and current of the TMC2130 driver manually. But, in which cases some of the components could burn up?

I need to know if something will burn up beforehand I plug all the circuits: Ramps 1.6+ Arduino Mega 2560 PSU 12 V, 15 A 2 TMC2130 V3.0 Stepper motor driver 2 Stepper motors 17hs3401 ...
user avatar
  • 157
1 vote
2 answers
1k views

Is 12V and 15A enough to make work a Ramps 1.6 Plus and two stepper motors?

I want to make an order with this configuration Arduino MEGA 2650 R3 Ramps 1.6 Plus 2 TMC2130 2 Stepper motors 17hs3401 1 Fan But I am not sure what voltage and current would be enough to make it ...
user avatar
  • 157
0 votes
1 answer
192 views

What is the maximum input ratings for current, voltage and power for RAMPS 1.4, 1.5 and 1.6?

I need to know the maximum input for current, voltage and power for: RAMPS 1.4 RAMPS 1.5 RAMPS 1.6 I want to build a DIY 3D printer. RAMPS 1.6 can deliver only 270 W. but if I total my heatbed + ...
user avatar
  • 11