Questions tagged [ramps-1.6]

For questions specifically related to the RAMPS 1.6 controller board - The RepRap Arduino Mega Pololu Shield, or RAMPS for short, is an expansion shield for the Arduino Mega designed to fit the entire electronics for a RepRap 3D printer in a small, low cost package.

5 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
1answer
221 views

New RAMPS 1.6 not working

I just bought a new RAMPS 1.6 shield to replace my old RAMPS 1.4 shield. The problem is that it's just not working, the motors don't move, heatbed/nozzle don't get heated. It was all working with the ...
1
vote
0answers
417 views

TMC connection error; SSD1306

I have some trouble with my small I2S OLED SSD1306. When enabled in Marlin 2.0.1 it shows up great buuuut with a bottom line saying TMC CONNECTION ERROR. M122 in ...
1
vote
0answers
203 views

Possible short in a RAMPS 1.6 board

I have an FDM 3d printer that used to run on RAMPS 1.4. After accidentally destroyed that board, I bought a 1.6 board to replace it. I have it connected to a 12 V 30 A power supply, but when ...
0
votes
0answers
49 views

RAMPS 1.6+ steppers not working

I recently purchased a RAMPS 1.6+ and it connects to my Arduino Mega 2560 just fine. I am able to use Pronterface to heat the extruder and the hotbed but the motors refuse to work. I have the jumpers ...
0
votes
0answers
240 views

RAMPS 1.6 power connector caught on fire while heating bed

I built a 3D printer from scratch originally using a RAMPS 1.4 shield with Arduino Mega as a controller. About a week into the printer being finished and working well I installed a heated bed. It ...