Questions tagged [reprap]

For questions regarding RepRap (replicating rapid prototyper) project, its Firmware of the same name and related topics as FFF (Fused Filament Fabrication).

9 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
253 views

How to add a patch to "Marlin_main.cpp"?

According to this question, MKS 12864OLED Display setup, I need to add a patch to "Marlin_main.cpp" but this a large file with 14789 lines of code! I don't know ...
2
votes
0answers
70 views

Z Axis homes, then bounces up 15 mm and stays there when printing

Prusa, I3 Mk2. Marlin 2.0.3 The test model printed fine prior to installing Marlin 2.0.3. It's not the slicer or GCode. I tried several models, and all of them worked perfectly prior to the update. ...
2
votes
0answers
336 views

Prusa i3 Mk2 (RepRapGuru kit) stops extruding mid-layer

So I've been fighting with this all weekend, figured I'd see if others have suggestions. When I attempt to print, my printer will go just fine until about the halfway point on a layer, then there'll ...
2
votes
1answer
448 views

Wrong Z-Axis movement in G-Code

Alright so I bought a broken UP mini. There was only a defect on the board so I connected the components to a Duet 2 Wifi. Everything is fully operational and I can manually move all axes correctly ...
1
vote
0answers
44 views

TMC2208 v1.2 stepper motor drivers not detected on SKR 1.4 turbo with RepRap firmware

I've upgraded my board to SKR1.4 Turbo with RepRap firmware. Everything works, but motors move double the request. M112 reports them as 'no-driver-detected'. ...
0
votes
0answers
46 views

Generating height map with Rep Rap

I recently did a G29 (run mesh calibration) and my printer did a 25 point probe and reported back the stats to the console. After this I went to the height map section and it says "height map ...
0
votes
0answers
62 views

Problems with "Discount Full Graphic Smart Controller"!

I bought a new "RepRap Discount Full Graphic Smart Controller" for my printer. I'm having a hard time installing it. LCD wouldn't turn on and a ticking noise was getting out of the buzzer. ...
0
votes
0answers
202 views

Can't manage to force my print to standby while I insert a nut - Prusa Slicer and Tronxy XY2 pro

I use the Prusa Slicer on a Tronxy XY-2 pro which I believe uses RepRap firmware. I believe it uses RepRap firmware because I had to input it into the Prusa Slicer initialization questions, but I'm ...
0
votes
0answers
40 views

How to fix a Duet3D board on an Ender 3 frame pausing mid-print

I have just installed a Duet3D Wifi 2 on an Ender 3 Pro. I sliced my first print using Cura and uploaded it via the web interface. It prints fine, except that it pauses for 10 seconds several times ...