Questions tagged [retraction]

Use this tag for questions about retraction of filament.

4 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
3
votes
0answers
158 views

Retraction fine but recovery occasionally just doesn't happen

I'm having issues with retraction. My printer prints very well normally, but has an intermittent problem with retraction: the retraction itself always happens, but sometimes the subsequent recovery ...
2
votes
2answers
91 views

Inconsistent layer widths and uneven outer walls

I have problems with layer widths and uneven outer walls on my 3D prints. Sometimes layers are squeezed and sometimes pushed outside. I noticed that these problems happen when there are retractions on ...
2
votes
1answer
65 views

Problems with ColorFabb XT: over extrusion

I could really use some help here. I am trying to print with ColorFabb XT and have been having an overflow problem, which creates an accumulation of material on the nozzle tip creating stringing and ...
2
votes
1answer
212 views

Extusion rate limiting and firmware retract

One frustration I have with Cura is that it has no way to set print speed in terms of a volumetric extrusion rate, when extrusion rate is the main physical limiting factor for how fast you can print. ...